[WANTED] Stainless steel driver seat back panel mouldings

[Richard kolin]

Stainless steel molding for 1967 barracuda fastback driver seat back panel.

 

[RedFish]

You would need to see this trim rusted badly to know it isn't stainless. Anyway...
Some earlier model a-body buckets do have the same backs with chrome trim. Well almost the same. Earlier trim will have little clips inside it that attach it to the back. Your 67 should have dimples stamped in the edge of the back so those little clips were no longer req'd. You can leave the clips in there, just slide them to a location away from the dimples. Hope this helps

 

[Richard kolin]

Looking for stainless steel or chrome molding for driver seat back panel for a 1967 barracuda fastback show pic if you have any.

 

[barracudakid]

do you need all 3 pieces?

 

[Richard kolin]

do you need all 3 pieces?

Yes send pic .

 

[barracudakid]

On the road tomorrow
Info Thursday

 

[Richard kolin]

On the road tomorrow
Info Thursday

Ok mine are rusted through and can not be repaired.

 

[Richard kolin]

Ok mine are rusted through and can't be repaired I tried but two many holes to thin to weld