Is anybody running a tubular weld in driveshaft loop with full exhaust? Pics and info would be helpful. I have a loop but can't seem to figure out to run it with the exhaust pipes.
I don't know if these pictures will help or not. We haven't installed it yet but this is a driveshaft loop that is intended to bolt onto the transmission cross member. 3 piece design constructed out of 1/4" steel with adjustment to locate the loop forward/back. It's actually assembled wrong right now. The 2" offset should be the other way.
Yeah, I had to modify it a bit and tacked it to the subframe connectors but when I went to install the exhaust there is no room for both. I bought the loop at the nationals in the swap met section but maybe it is for a chassis car. I was just wondering if anyone has solved this problem already