Grampas Toy
Well-Known Member
Here are the pictures that go to the first post.
#1 4" V.W.on the left mopar 5-1/2" right
#2 same
#3 same
#4 after plasma cut grind even ( only rears)
#5 check edges w/ feeler gauge,,grind down high spots
#6 same as #5
#7 Cut just behind the weld,,don`t try to cut weld.(it`s too deep)
#8 Ripples from rolling,,smooth out
#9 Measure (ears) make them the same.
#10 When your close,,mark edges w/marker roll around on table exposing high spots (all edges)
#1 4" V.W.on the left mopar 5-1/2" right
#2 same
#3 same
#4 after plasma cut grind even ( only rears)
#5 check edges w/ feeler gauge,,grind down high spots
#6 same as #5
#7 Cut just behind the weld,,don`t try to cut weld.(it`s too deep)
#8 Ripples from rolling,,smooth out
#9 Measure (ears) make them the same.
#10 When your close,,mark edges w/marker roll around on table exposing high spots (all edges)
Attachments
-
DSCN0890.jpg112.9 KB · Views: 220
-
DSCN0891.jpg96.9 KB · Views: 245
-
DSCN0892.jpg98.2 KB · Views: 203
-
DSCN0893.jpg113.4 KB · Views: 194
-
DSCN0894.jpg121.1 KB · Views: 222
-
DSCN0895.jpg116.3 KB · Views: 235
-
DSCN0896.jpg93.9 KB · Views: 192
-
DSCN0897.jpg83 KB · Views: 182
-
DSCN0899.jpg65.6 KB · Views: 191
-
DSCN0901.jpg87.8 KB · Views: 192