Recent content by 1967 GT Vert

I just bought a pan from Mancini. Comes with new pickup and new dipstick.

I just bought a 5.2 built motor with the denso alternator. it is already set up for 1 wire using this conversion the guy bought on ebay...

Yes. For a inline 6 jeep engine. Running great with it.

Nice driver right now! Always a work in progress. But this is what I have done in last 13 years. Just recently tuned up with and manifold gasket and carb. Slant 6 2 Barrel 2 Build Sheets What I have done... Top frame sanded and painted Seats, new foam and covered in original color. New carpet...

I purchased a new carb for my slant 6, as I plan on rebuilding my old one eventually. Can some one I'd what this part is and what it does? My old carb didn't even have it.

Thanks

Looking at a 318 but date stamp is giving me problems. Can anyone assist?

Slant 6 2 Barrel 2 Build Sheets What I have done... Front disc brakes New front end New rear shocks New tires Hei ignition conversion 2150 Carburetor New brake lines New fuel line New fuel tank New dash circuit board new heater core Resealed heater box New emergency brake cables New flexplate...

I am in need of 2 good 9 inch b Drum brake wheel hubs as my bearing races were loose I was able to shim them for now but want spares. Any aftermarket? Please supply part numbers.

1967 Dodge Dart · Sedan · Driven 70,000 miles CONVERTIBLE 1967 Dart GT. I have the build sheets Slant 6 automatic What I have done in the past 8 years to her HEI conversion 2150 carb Rebuilt whole front end suspension Rebuilt steering box Radiator and overflow Heater core and heater box rebuilt...

Been thinking of adding a cruise control to my 1967 Dart Convertible. Has anyone done this recently? Years ago I installed a Sears unit in a 1980 car with pickup on the drive shaft and dash buttons. Looking for recommendations as there are plenty of NOS Sears units on Ebay. Part numbers...

Sorry It is not a TMI. It EMPI Here is an link from Amazon https://www.amazon.com/gp/product/B073WK1HG6/?tag=joeychgo-20

I did look at those consoles too but they are universal and didnt fit my needs

I just wanted a simple center console to hold sunglasses and a cup if coffee. Started to plan on building one when I found this one made by EMPI for about $55. Just had to trim the back side a little and I glued a paint cap to the underneath to close off the shifter hole and a couple of small...

The one Sedanman posted looks like it is made for an off centered tunnel which would be nice to have Otherwise I will have to build one.