Recent content by 1973Kathleen

I am currently swapping my 6 cylinder k frame out of my '72 demon for a v8 k frame out of a '67 Barracuda. I have one side competed with everything bolted back on with new suspension components just waiting on a strut rod bushing to come in the mail because it was all dry rotted and no good. I...

It seems to be getting fuel my filter is always 90% full. I’m not sure if that’s good judging that the one guy said only half. I recently replaced the fuel system except the fuel lines back in early 2023. It ran perfectly until I put a four barrel on it and it was starving for gas which was...

Thank you to all that have helped they were the same pumps only difference was the brackets and the pulley was a little further out so after switching those they worked perfectly

Hello, I have a 1973 Dodge Dart Sport with the 318 and 904. I was driving down the road a few weeks ago and my axle bearings went out. After I replaced those I went to test the car out. The car wouldn’t stay running. You’d drive down the road and it would just die and when you try and give it...

my whole issue was the pump didn’t burn up but my pulley was lose and i could move it back and forth and it was leaking from there

I have a 1973 Dart and a 1972 Demon. the dart has a 318 and the demon has a 6 cyl. My darts power steering went out and i had one off a 68 charger it looked aftermarket because it seemed 100% different and the bolt holes didn’t line up to it so i have a 72 6 cyl pump in storage and i was curious...

I'm not sure what yoke it is its the 741 Case

I have a 1973 Dodge Dart Sport. I recently put a 8.75 rear in it and when I went to install the driveshaft it was too long. Does anyone know the size I need or have a link to purchase one the correct size. Thanks

Okay Thank you

I need to replace my transmission lines (they got kinked) and on jegs it says there is some for a 74 and I was curious are they the same as a 73? Right Stuff YTC7401: 74 Dart 318 904 - Trans. Cooler Lines 2 Pcs. - JEGS That's the link to the lines

ill look into it all lol, its the only way ill learn

I wasnt there when it was installed. Its at a votech school that im in and the afternoon session installed the transmission. all i know is the one guy made me disconnect the torque converter from the engine and when removing the tranny he spun it back because when i removed the transmission the...

If it doesnt is it the dust cover?

It was open headers so im not sure if it was there or not but i didnt hear it. i tighten the torque converter bolts and even torque them down.

Yes it has been apart about 2 or 3 weeks ago was just started last week