Recent content by 19Dodge71demon

great pics of that thank you!!

Thanks for the Pics Muslca! Is that tail panel blackout decal 2 pieces or a single piece? If it is a two piece is the area where the two pieces meet on the outside of the tail lights noticeable ? I saved your pics and enlarged them and your blackout decal looks like 1 piece.. Thanks!!

Hey guys got a question on 71 Demon 340 tail panel blackout graphics. Was the factory tailpanel blackout one piece or two? It seems like all the repros I've seen are two pieces - an upper part and lower part. I do not ever remember seeing any seams on the outer tail light striping..Is there a...

no it will not stop leaking once you torque the lugs. I just had a brand new one leaking from the lug nut holes. I found a void in the inner silicone seal and sent it back to Jegs. If yours is used I would strip out all the old sealer and reseal it. Good luck!

These rotors were brand new from a Diplomat in the wrecking yard, so before I put all this stuff on I ordered new inner & outer bearings and races, and new dust seals. Spindles were a nice used set. I've been mesing with mopars for almost thirty years and have owned my Demon for over 25 and...

Stormy69 - did you ever figure out the problem? I have the exact same problem on my 71 Demon with 74 duster disc brake conversion..

the horshoe looking gussets around the lower control arm hole are reinforcements only found on the 340 K frames. Yes the washer in the front signifies 340 engine..

thanks guys! I have the spring clip, just not on in pic. I don't see how some guys get lucky on 4 speeds with the stock Z bar. I guess I'm going to order one of the TTI modified Z bars tomorrow and try that.

Hi everyone. I've just installed my 340 motor / 4 sped trans and have a question on the position of the Z Bar. Is the bellhousing side of the Z bar supposed to butt all the way up against the bellhousing bracket? How far over is the Z bar supposed to slide over on the frame side ball stud? I've...