1WildRT's latest activity

  • 1WildRT
    That's the beauty or the 904/998/999 Low gear sets are stock in the 998/999... So 82 &l ater model L & M body cars, Most junk yards as...
    • 1767677411230.png
  • 1WildRT
    1WildRT replied to the thread TKX vs T56.
    Like I posted earlier, there are options... If you can fabricate you can make someone work.... You say it's not pretty, well when the...
  • 1WildRT
    1WildRT reacted to ESP47's post in the thread TKX vs T56 with
    Like
    Like
    .
    I made up this bracket to get my TKX shifter located correctly for a factory console. It's not pretty but it gets the job done. Only...
  • 1WildRT
    1WildRT reacted to andysauto1's post in the thread 2026 Car Goals- What’s yours? with
    Like
    Like
    .
    After 2 1/2 years getting it where I wanted it, I'm just going to drive it and enjoy cruising
  • 1WildRT
    1WildRT replied to the thread 2026 Car Goals- What’s yours?.
    Sounds like most of you guys want to work of stuff... I just want to drive mine... The more the better... Unfortunately the reality is...
  • 1WildRT
    Seventeen years... And somehow "It's Back!!!!!" Since someone else dug it up... Here's a single stage paint job... Pretty decent...
    • 2.jpg
  • 1WildRT
    Another was a 64 Buick Riviera G/S with the dual quad 425.... Engine had been built by a local speed shop but the car sat unfinished for...
  • 1WildRT
    Bright Orange 71 Pantera.... Worked on it back in 1982, came into the shop for electrical stuff... I was drooling like a fool... When...
  • 1WildRT
    1WildRT reacted to cli55er's post in the thread TKX vs T56 with
    Like
    Like
    .
    I have a Lakewood as well…. Was .004 right out of the box. They are made by Holley I believe.
  • 1WildRT
    1WildRT replied to the thread TKX vs T56.
    The two I used were both Lakewood.. Good piece...
  • 1WildRT
    1WildRT reacted to DionR's post in the thread TKX vs T56 with
    Like
    Like
    .
    SST sent me this one, same one @340sFastback had and swapped out for the QT bell. Bell Housing – Tremec T56 Magnum to Mopar LA Small...
  • 1WildRT
    1WildRT replied to the thread TKX vs T56.
    The guy I got my trans from had a Q/T bell... The run out was over .070... I machined custom offset dowels to center it up... Once that...
  • 1WildRT
    Medical grade oilless compressors are kinda specialized... Not a lot of air, but really clean consistent air... I had a Corkin Medical...
  • 1WildRT
    That IR Should do everything you need it to do... If you pick up a blast cabinet you'll have to let it catch up... Blast for 10 minutes...
  • 1WildRT
    1WildRT replied to the thread TKX vs T56.
    Mine is a TKO but it's Ford format cause that's what Kiesler used way back in the day.... Silver Sport sells a bell housing that has...
Back
Top Bottom