Recent content by 2times

Dude i can totally relate, bought all new MSD gear, 6530 and MSD coil, ran fine on dyno and around town, drove it to the track 2.5 hours away and the MSD coil takes a dump, leaving me and the side of the road in the middle of no where. Emailed MSD and they said no worries you pay shipping to the...

G'day mate, your setup is looking good, how is the clearance with the 4" pipe and the wheel at full lock? I've got a dummy engine in a mockup engine bay and it looks like a 4" pipe would be close to touching the tyre at full lock. I guess it depends on tyre size and how low you have your car...

G'day Mate, ECU wise i dont think you can go past http://www.efisource.com/shop/ms3-gen3-hemi-plug-play-gold-box/ Uses all factory sesnsors has a base tune in it (for standard engine) 2 rpm limiters, NO2 input, switch between fuel maps, comes with a loom too so makes it piss easy to...

It depends on a few things. - Valve heights? - Are you going to modify the heads to suit dual springs? - How much boost do you plan on running? I run standard 360 heads with no modifications so i was limited to spring choice. I went through valve spring catalouges at my local parts store and...

I run it on LPG (Propane) blow through. Propane is quite popular in australia and its quite easy to setup and cheaper to setup compared to a Petrol (gas) setup. I run an ebay 600x300x100mm intercooler, 3" in/out I have also just fitted water injection not to cool down intake temp but to...

G'day mate, i've been runnning a similar combo for nearly 3 years now. 318, stock bottom end, cast pistons, stock rods, stock crank, stock bolts etc 360 heads no milling, Felpro gaskets, ARP head studs Victor single plane 360 cast exhaust manifolds, 2" piping into Y into T4 flange MasterPower...

WOW! Great info thanks guys!! Yes the seats will be cut and longer stem valves will be used so no issues with the spring rates and retainer clearance. 64physhy, thanks for your experience and good to know these EQ heads can make good power! How long have you have your engine running for? any...

Thanks for the quick reply fellas! I was hoping i could all ready use the rollers i've just bought, Chevy style 1.6 and just buying some ARP 5/16 to 3/8 studs...

Hi Guys, i'm new to this forum looks like a great place to ask some questions and get some help, I'm building a 360 using EQ magnum heads and i've purchased roller rockers to suit, the question is standard magnum rocker studs are 5/16 into the head and 3/8 to the rocker assembly and i'm not sure...