33IMP's latest activity
-
33IMP replied to the thread Tire sizes, AGAIN?.If you don't know the width or backspace of your rims, you might have sevens. 245s will fit on sevens fine, imo. For an early A, the bs... -
33IMP replied to the thread 1974 duster 1945 holly.Why are you using an eighty year old carburetor? Sorry, I just had to!
-
33IMP replied to the thread Tire sizes, AGAIN?.Those 14x8s might work on a Duster or Demon, with the right tire. Sell em, and buy another pair of 6s (or 7s) for the rear...
-
33IMP replied to the thread What wheels.15x7 are aftermarket or Ford only. Mopars were 14" only.
-
33IMP replied to the thread What wheels.Fords.
-
33IMP replied to the thread Tire sizes, AGAIN?.If you have the backspace I think you have on the 14x8s, there's not a chance that you'll be able to get an appropriate tire for the...
-
33IMP replied to the thread Brainstormin' 440 vs 5.9 ....Heck, it's so cold here , I'm forced to put on a heavy shirt to play with the dogs in the morning. It drops down all the way into the...
-
33IMP replied to the thread Low band apply or not?.I have two cars with rmvb, both without low band apply. If I were to do them again, I would definitely do low band apply. But I believe...
-
33IMP replied to the thread Brainstormin' 440 vs 5.9 ....Imo, bottom line..... Unless the owner of the 440 (whoever, not necessarily 318wr) does SOMETHING about the 7.4 to 1 comp ratio, the RV...
-
33IMP replied to the thread Brainstormin' 440 vs 5.9 ....My comment was a hypothetical, brought on by your 4.04 request. The crank alone would be double 5.9s budget. Sure would be interesting...
-
33IMP replied to the thread Brainstormin' 440 vs 5.9 ....If I remember right..... The heads on those 7.4 pistons are thicker than ****. So.... throw a 4.150 crank in it, whack .050 or so off...
-
33IMP replied to the thread Brainstormin' 440 vs 5.9 ....If your dad pulls a trailer, or loads the bed heavy, put the 440 in . Otherwise..... the 318 would be fine. Heck, if the slant runs...
-
It’s a shame someone doesn’t make an inexpensive drop in (balanced to stock LY rods and 1.922 C.H.pistons) 4.05 inch 440 crank. Moving...
-
33IMP replied to the thread Brainstormin' 440 vs 5.9 ....With 7.4 compression and virgin heads, I'd bet that same engine would struggle to make 360 hp.
-
33IMP replied to the thread Brainstormin' 440 vs 5.9 ....I'm pretty sure that was the idea. Shave the heads a bit too, and add a steel shim gasket. Probably get high 8 cr from 7.4. (Depending...