340 RR's latest activity
-
3340 RR replied to the thread Mopar 8 3/4 Clutch Type Sure Grip Case 742.Another question, I have installed both sides of the button with the pin into the central hole between the 2 gear sets. When holding one...
-
-
3340 RR replied to the thread Mopar 8 3/4 Clutch Type Sure Grip Case 742.Haha, that makes two of us now. Thanks for the suggestion!
-
3340 RR posted the thread Mopar 8 3/4 Clutch Type Sure Grip Case 742 in Transmission and Drivetrain Tech.Hey guys, I'm in the process of determining shim stack on the pinion gear in the dif. I believe I have read that the torque of the...
-
3340 RR replied to the thread 8 3/4 rear end confusion.Actually, I just found the answer to the spacer/button question. I wasn't aware that this is where the button actually ends up. I...
-
3340 RR replied to the thread 8 3/4 rear end confusion.Hello, hope everyone is doing well. I am currently assembling my 8 3/4 differential sure grip clutch type carrier after I took it apart...
-
-
3340 RR replied to the thread 8 3/4 rear end confusion.Hey guys, hope everyone is doing well. I’m in the process of tearing down the differential and I have already ordered new bearings and...
-
3340 RR replied to the thread 8 3/4 rear end confusion.I pulled the diff and was able to find the second button at the bottom of the casing. The button honestly looks completely intact so idk...
-
3340 RR replied to the thread 8 3/4 rear end confusion.I purchased a flexible magnet and was able to fish it to the bottom of the dif. Couldn’t get ahold of the button but each time I brought...
-
3340 RR replied to the thread 8 3/4 rear end confusion.Hello everyone, I have another update. After almost a week straight of rain, I was able to get outside and take out the passenger side...
-
3Yes
-
3340 RR replied to the thread 8 3/4 rear end confusion.Left hand?
-
3340 RR replied to the thread 8 3/4 rear end confusion.Okay I will check to see if the passenger side button is still in place. I guess I got lucky that the driver side didn’t fall into the...
-
3340 RR replied to the thread 8 3/4 rear end confusion.Okay I see, I’ll pull the passenger side axle again to see if the button is still in place. I’ll do my best to get the axles in without...
-
3340 RR replied to the thread 8 3/4 rear end confusion.I was able to get the button with the pin through it back into the hole and all I did was slightly swipe the magnet sideways and I stuck...
-
3340 RR replied to the thread 8 3/4 rear end confusion.I finally decided to go the easy route and shine a light through the axle housing to see what's in there, I know I should have done this...
-
