340 RR's latest activity
-
3340 RR replied to the thread 8 3/4 rear end confusion.And let's just say I do have the thrust buttons with the pin and they are out of place and maybe fell to the bottom of the dif, would...
-
3340 RR replied to the thread 8 3/4 rear end confusion.srt12-340, I keep reading that the cone type has a thrust block and that the clutch type has the buttons and pin. These are very new...
-
3340 RR replied to the thread 8 3/4 rear end confusion.I have tried having someone rotate the driveshaft. I'll give it another shot tomorrow. So you're just saying to spin the driveshaft back...
-
3340 RR replied to the thread 8 3/4 rear end confusion.Hello everyone. So I tried most of the ideas provided in this thread and here's how it went. As you all know, I was having lots of...
-
3340 RR replied to the thread 8 3/4 rear end confusion.Thank you guys for the replies, I do believe it is just an issue with lining up the secondary splines. Here are pics of the wheel seal...
-
-
3340 RR replied to the thread 8 3/4 rear end confusion.Thank you everyone for the replies! I will first shine a light to make sure that the thrust button hasn't interfered with the splines. I...
-
3340 RR replied to the thread 8 3/4 rear end confusion.So should I put it in neutral and spin the rear end to try to line up the secondary splines?
-
3340 RR replied to the thread 8 3/4 rear end confusion.Oh okay so if it’s a sure grip then it would have to be in neutral for the rear axles to spin? Didn’t know that, thanks.
-
3340 RR replied to the thread 8 3/4 rear end confusion.It’s in park and I know the driveshaft won’t turn but wouldn’t the axles still be able to spin?
-
3Hello guys, I was re-doing the brakes on my 1973 roadrunner with a 340 and I ended up doing the inner axle seals as well. As you guys...
-
3It doesn't look like you've got everything assembled, so I wouldn't be too worried about it. The shoes have to be sitting correctly on...
-
3340 RR replied to the thread Drum and Shoe Size.2nd photo also has the shoes sitting too far out, the angle just hides it.
-
3340 RR replied to the thread Drum and Shoe Size.They’re all from the same setup, just different angles. Look at 3rd photo in post #6. Don’t those shoes look to be sitting too far out?
-
3340 RR replied to the thread Drum and Shoe Size.I have attached a couple different photo angles to show how the new 2 1/2in shoes sit in relation to the spring and cable holder. They...
-
-
3340 RR replied to the thread Drum and Shoe Size.I appreciate that. I just went and measured and I got 1.75" which means my shoes should be 11x2.5". I tried putting new 11x2.5" shoes on...
