Recent content by 340_duster

Very nice looks better than New!

Looks very nice. Is that a new dash bezel?

Thanks for the reply.

Ok maybe I should reword this. Can anyone who has put a cross ram Hemi in an A body , tell me what accelerator cable they used?

Does anyone know what was the correct length for the accelerator cable for the Hemi Cross Ram

Firefox same

Thanks very much for trying

Can some tell me what this trans is from PK4431557 9163 2731. Thank you

Thank you guys so much. I have the 4 bbl throttle cable bracket, but I could not figure out the connection at the carb, but that Holley bracket makes it simple. Thank again. :)

Looking for ideas on how to connect a Edelbrock RPM air gap manifold with a Holley 4160 to the throttle cable and kickdown lever. Trying to use factory linkage, but we are open to ideas of aftermarket. Thanks

I am looking for a 904 transmission output shaft support it has a number cast into it of 2466881 , and it supposedly fits 66 to 86. Thanks in advance Bob

Thanks for the info much appreciated.

Which regulator works for the 67- 69 Barracuda rallye dash. They sell 2 different models, IV3 and IV4

Well after further review, I am now in need of a large ball joint RH upper control arm.

I am changing out suspension pieces on a 74 dart right now and have the same concern with the upper ball joint boots.