Recent content by 67dartGTconvertible

I have a 74 ramcharger and the latch in the driver door is missing a part that controls the lock so I can’t lock it. It otherwise works. If no one has a working one I may be able to use a broken one if it has the part that the pencil is touching (picture is of the passenger side latch)

PM sent on manual steering box.

Leaving it full length is fine as long as you are careful with wheel selection. The video above shows that towards the end and it is on a 68 dart. I think dusters have a bit more room for tires. The offset of the drive shaft is shown as well looking down the tunnel.

Has anyone used the stock explorer shock plates? If, how did they work out? Any pictures?

New pricing!

Post updated.. sold stuff removed and new stuff added

I believe it will. I think the inner fenders were the same on all a bodies 67-74.

I can try to do it tomorrow morning.

New lower pricing: 1. SOLD! 2. SOLD! 3. Price reduced! New price $20 - Radiator out of 67 dart w/ slant 6. Car ran good when removed. Did not run hot and never leaked: 4.SOLD! 5. $10 for all (13) hubcaps 6. SOLD! 7. $100 - (4) Big bolt pattern Rally Wheels. Only one shown but they...

Thanks for the feedback. It sounds like the Elelbrock 5090 would be much better. 9.24 compression and better choices for rockers and likely a better made head. This is why I ask questions here.

This is what speedmaster has currently w/ combustion chamber listed at 74cc: Mopar Chrysler BB 383 440 265cc 74cc Hydraulic Roller Assembled Cylinder Heads According to diamond pistons calc 74cc would give me 9.32 compression ratio. Is 74cc accurate for these heads?

What are the chrome pulleys go to?

Has anyone used these heads? Power Products, Chrysler BB Aluminum Head, 210cc/70cc, Assembled, Hydraulic Roller, Pair-Competition Products I am building a 400 on a budget (so did not 0 deck). I am interested in these because the price and because they have 70cc combustion chambers. I’d really...

No problem. There aregood YouTube videos out there for shortening the rear if you are looking do that. I cannot say if you can have your driveshaft reworked but as you can see in the video I sent, the flange is different on an 8.8