Recent content by 68dartuk

Hi,I think that I will have to modify the firewall slightly mainly because i don't want start blanking anything off on the engine, i want it to run as it should do, i will be getting a remote filter set up and have used a Holley sump.

thanks for the heads up , I'll put that on the ever increasing list

I did yes,there's no gearbox on at the moment so I'm hoping that when I level it up that it will fit, fingers crossed.

Got the engine in today, I’ve decided not to start cutting and moving things around, I’m going to go with the blanking plate and remote filter i just wish I had gone to the TTI website first.

I'm going to put the motor in tomorrow and see what it looks like,see if altering the mount is feasible.

Thanks for that, just checked on Mancini where I bought them from and they don't say anything, but they do show a plate as well as some pictures that don't really correspond with the actual mounts.Looks like I'll be getting another order together.

Hi guys, spot of trouble in the UK, I’ve recently got a few parts together to install a 6.4 into my 68 Dart. I needed a new K frame so got the later one with spool type mounts, i also got the TTI mounting kit that’s where my problems are now because the Mopar oil filter adapter doesn’t fit with...

There’s no going back now, time to get a shopping list together.

Thanks that’s great, definitely confusing

I’ve been looking at the terminator x max but it says non VVT only for the DBW

Thanks that’s great, made things a lot clearer The 426 just had to go

This is the engine I’ve just taken out

Another thing what throttle body are people using when converting to a cable.

Ok that’s sounds good, I think to start with I’ll just leave it, does the mds and vvt work hand in hand together, so it will just run normally without either? Probably in the future I’ll do the mds delete kit once it’s all sorted.

Hi guys I’ll be putting a 6.4 into my dart, the engine is a esg code so has mds, I will be using a holley terminator x. Question is I’m going to use a 6 speed manual transmission, do I need get the mds/vvt Holley wiring loom to enable it/ disable it or get a mds delete kit. Engine has around 48k...