69conv's latest activity
-
69conv replied to the thread Oil be darn.Thanks, she's 90% there just need to solve this problem. -
Nice car! Good luck!
-
69conv replied to the thread Oil be darn.Just to be sure I may disconnect the pcv and plug the inlet to the carb and see what happens. Kinda the problem is there is so much iol...
-
69conv replied to the thread Oil be darn.I will never be your caliber builder but i thought I would check that. I pulled the pvc and ran a tissue up it from both ends and there...
-
Unless the pcv baffle is oem or just like oem, I’d pull the pcv valve and put another breather in the hole. Drive it and see what...
-
The above video give you an idea how it's done.
-
69conv replied to the thread Oil be darn.Never considered solder, awesome recommendation. Thank my friend!!
-
-
Well that's gotta come apart.
-
69conv replied to the thread Oil be darn.I did retorque the intake but nothing seem out of spec.
-
The angles on intake may have been misscut by edelbrock. Wrong angle or intake wider at one end than the other. You need to check it...
-
69conv replied to the thread Oil be darn.I'm kinda leaning toward the intake angle too. I dont know how to check the angle, maybe plasigauge or clay to check clearances with a...
-
69conv replied to the thread Oil be darn.Thanks for the heads up. Considering a compression test but the rings look so wet it may not be conclusive. Motor doesnt run like...
-
69conv replied to the thread Oil be darn.moly
-
69conv replied to the thread Oil be darn.So u thinkin run some seafoam and drive it more?