Recent content by 6SLNGR

Thank you for the reply

Car does not stay running!

where does this spring go? Found it laying under aircleaner. Would this cause the engine to be hard start/not stay running?

Thanks. I wasn't sure if the standard remains were decent enough

I snapped the bleeder screw and am thinking of just replacing the calipers. Where is the best place to get replacement calipers? 1975 dart custom 225 6 Manual front disk/rear drum

Out of stock

Where can I get the hard lines for the master cylinder? I am installing a new master from Dr diff.

Thank you all for the in depth info. I have much to do but a clearer path now.

Could be ecu. Here is a picture.

I will inspect closely and make needed repairs. There is bare wire showing on the fuel pacer wiring. (It is currently disconnected) Also I was told the voltage regulator was replaced but it looks like the last leaked black goo all over the engine bay. I will look for a dimmer bulb and inspect...

I recently bought a 75 dart custom and it will be my daily driver. What wiring should I replace as a preventive measure? Ignition , starting and charging systems? Also the ignition lamp bulb gets super hot, is this normal? Or should I sort that out immediately?

I believe that is from the last one. The guy I bought it from said he replaced it.

I just bought a 1975 custom for a daily driver I need lots of parts (listed below). I don't want to buy junk but expensive doesn't mean quality. Master cylinder Gas tank Sending unit Power steering pump or rebuild kit Wire and connectors Fuse block Tires Wiper bushings I might be forgetting...

Thanks for all the responses.

Here is what I got.