6T9QDA's latest activity
-
66T9QDA replied to the thread 340 exhaust heat shield needed for Van's to repop..I don't know why I remember the number, but in the early 80s those trunk panels were available NOS from Chrysler for $108. That's close...
-
66T9QDA replied to the thread Hi-po exhaust manifolds.Good point. There's no way to get cone washers under the sleeve nuts, but it might not be a bad idea to put them under the four center...
-
66T9QDA replied to the thread Coolant in cylinder 8 on 318.Deck dowels too long or not seated?
-
66T9QDA replied to the thread Hi-po exhaust manifolds.I believe this is correct. Some of the available hardware kits come with more cup washers than you need, but information varies about...
-
-
66T9QDA replied to the thread How much trouble am I in?.I got the filter adapter back on and ran it for 30 minutes. No leaks and no signs of cross-contamination. It's an aluminum 90*...
-
66T9QDA replied to the thread Making power out of the 318..750 solid roller
-
66T9QDA replied to the thread How much trouble am I in?.The oil came out as a uniform opaque tan. Didn't smell like coolant. I heated a little of it and the water evaporated off, the oil...
-
-
66T9QDA replied to the thread How much trouble am I in?.Regular Performer with a 1406. Early 340 exhaust. Had the stock cam reground to xe250hr specs. I think the engine will hit the goals...
-
66T9QDA replied to the thread How much trouble am I in?.Good thought. I don't recall exactly, but it was red and the streaks are whitish. I'll do the oil change with UV and report back.
-
66T9QDA replied to the thread How much trouble am I in?.Yeah, that's probably sound advice. I think I'll change the oil and filter, and add some UV fluid to the coolant. Run it to...
-
66T9QDA replied to the thread How much trouble am I in?.Yes, I'll crack the drain plug and see what comes out first, but I'm not expecting much water as I can't see that the level in the...
-
6A little backstory: my '69 Barracuda is a very long-term project that I work on when budget and enthusiam allows. About ten years ago I...
-
66T9QDA replied to the thread Making power out of the 318.To the OP, your big advantage is a wealth of knowledge right here at your fingertips. Most of us started playing with engines long...
-
66T9QDA replied to the thread These guys are on top their game.Back when 3D printing first became a thing, I read about some race team (about the only ones who could afford it) that was printing...
