I even installed a drain plug in the stamped pan but the rubber gasket with the stamped pan didn't seal. Leaked like the Titanic. I also use the plastic dip around the shift cables (65 transmission) as they would tend to drip when sitting a while. Now that I have posted this, I expect red...
And send it to Extrude Hone Extrude Hone - Deburring - Polishing - Finishing metal parts
It is an abrasive material forced through items that smooths the interior of your manifold... places where it is hard to reach
For me, it's an unknown. The car I just acquired; the owner told me that the camshaft was changed. By the roughness of the idle, I deemed it true, but I don't know the specs of said camshaft nor does the previous owner. This is what "I was told".
Just went through this crap and I just installed a cable from Bouchillon Performance BPE TorqueFlite Kickdown Cable Kit - Bouchillon Performance Engineering .
A little pricey but it works and I was tired of the trial and error of what I needed vs. what I had :rolleyes:
Good luck:thumbsup: I...
Do your homework and get prices for everything. It might be easier and cheaper to just get an engine from Blueprint or another builder of your choice. It'll save time too. Just throwing it out there.