92b's latest activity
-
92b replied to the thread When good is not enough, Camshaft time again..No. -
I don’t know, but the TQ/hp columns are listed as “STP”(which in SF lingo is j607, unless the columns have been renamed), and based on...
-
92b replied to the thread To dyno or not to dyno?.Is it oil temp that gets too high?
-
92b replied to the thread When good is not enough, Camshaft time again..I wonder is that with sae1349 or std 607 correction factor?
-
92b replied to the thread Valvetrain Geometry.In the end I wonder, how much difference there is between 1/2 and 2/3. At what level of valve train stress would you have to be at for...
-
92b replied to the thread Valvetrain Geometry.I think the answer to that question is, it depends on the application and even then there may be some disagreement depending on where...
-
-
92b replied to the thread To dyno or not to dyno?.I use the same procedure with my depac, minus the shut off every 5 minutes. Are you shutting the engine off or just the load control? If...
-
If you want to know exactly what it makes, dyno it. If you want to tune it to be the best it can for what it is, dyno it. If you want to...
-
92b replied to the thread 30-day countdown to 12's.I might be remembering wrong but, I think you could use a tape measure to compare those two intakes.
-
92b replied to the thread Thoughts on a 390 cu in. stroker from a 318?.Right or wrong, and I'm not picking sides but, many people use the word torque when refering to horsepower that is at the low range of...
-
92b replied to the thread A855 - 5 Speed.How do you identify if it is early or latest design? Did anyone offer any insight as to what the change was that corrected the pop out...
-
I won’t. Fact is I have one more shot to do this this year. So I’m looking at the truck and the simple things that are possible to...
-
92b replied to the thread 30-day countdown to 12's.How will you know if the intake is better if you change the carburetor too?
-
92b replied to the thread oil/filter change info.Use the wix racing filter if it will fit. Make sure you have air filter/housing assy. sealed tight. Who did your carb?
-
92b replied to the thread oil/filter change info.Driven Gp1 is your best bang for buck. If you don't know your bearing clearance then start with 20w50 and go down if oil pressure...
