92b's latest activity
-
92b replied to the thread Brainstormin' 440 vs 5.9 ....What 440 and what 360 are you refering to? Are you looking at peak torque or average torque? -
92b replied to the thread Brainstormin' 440 vs 5.9 ....One thing I have noticed when tearing down magnum 360 engines is how well the cylinder walls hold up compared to the LA motors...
-
92b replied to the thread Brainstormin' 440 vs 5.9 ....Give the 440 what the 360 has. 9:1 compression with a closed chamber head with efficient ports proportional to the magnum heads. Good...
-
92b replied to the thread Brainstormin' 440 vs 5.9 ....They are being told to sit on their hands for now
-
I made a fly cutter by sharpening an old LS valve I had laying around. Worked great.
-
92b replied to the thread piston valve reliefs, how to.Claim is unlikely. Lots of hurdles and hoops for a claim to happen in this scenario.
-
92b replied to the thread Brainstormin' 440 vs 5.9 ....This is a similar build. 440 stock stroke, stealth heads. re-cut seats, clean up bowls, .050 quench, 10.4:1, comp XE 274H, 750 holley, 1...
-
-
92b replied to the thread Brainstormin' 440 vs 5.9 ....Below is a picture and specs for a pro tru piston. I haven't used one of these but it looks like a good bang for buck. It comes with...
-
-
92b replied to the thread Brainstormin' 440 vs 5.9 ....Are you using the cast iron open chamber heads?
-
92b replied to the thread Brainstormin' 440 vs 5.9 ....I think you can buy the pistons with rings. Moly will work. I wouldn't buy anything yet until you have a plan on paper. Are you keeping...
-
92b replied to the thread Brainstormin' 440 vs 5.9 ....If you are keeping the open chamber stock heads you might consider the KB 236 pistons.
-
92b replied to the thread Brainstormin' 440 vs 5.9 ....When comparing head flow on two different engines the assumption seems to be that if the flow is the same the potential HP and TQ will...
-
92b replied to the thread piston valve reliefs, how to.The rule has been 7k for about 20 years. What are your wild cam specs? What brand of piston do you have? How far is the piston in the...
-
92b replied to the thread piston valve reliefs, how to.You are not required to run a 6k rev limiter. It's 7k. 2025-Hobby-Stock-Rules.pdf https://share.google/atadii4vAjXBPSXlI
-
No, I didn't cut it on purpose as I wanted the intake to sit higher up on the head port. That way I could straighten out the roof where...
