Recent content by aa-1159

Still looking, Thanks

Looking for a console door lock latch for 73 Duster, looks like a piece of heavy bent wire Chester Virginia

Is there anyway to keep alternator excited at low rpm, Car idles at 850,(12 volts or less) alternator won't excite until around 1000 rpm, (14.4), above 1000 rpm 73 Duster, 360, has serpentine set up, Called manufacturer about pulley size, they said pulley made to spec of original pulley Don't...

I called them

I called them

I'm looking for a console overlay for a 73 duster in gloss black I've checked Phoenix Graphics Detroit Muscle and everybody else no one has one any idea would help

Want to Thank everyone for the help Changed distributor and it fired right up, I thought that was my problem all along, now have to rebuild or get a distributor cause this one is borrowed, Again Thanks

Disconnected distributor and touched ecu wire to ground gets a spark Will probably change distributor tomorrow, mine looks pretty ratty inside(pickup), all wiring is new. But that doesn't really mean anything

See prior reply

Did volt checks, see picture Converted to electricnic ignition Checked voltage at key switch, Voltage drops to 10 volt when in start position, see picture

Tried starting it again, Cranks, then tries to start when letting off key Only change i made was newer style vr, and 2 field alternator, ran separate wire from alternator to ballast resistor, using single post ballast resistor

I've tested ecu, it sparks Gonna check coil voltages tomorrow, Thanks

Evan's harness and M&H harness I'll check that tomorrow Thanks

New wiring in whole car, new ecm, vr, coil, ballast resistor, rotor, distributor cap,wires, plugs No wiring in car when I purchased it, just a rolling body Not spark when cranking, will fire one time (some times) when letting off key then will not fire at all after that sits for awhile then will...

68 Barracuda has no wiring Need diagram on how to wire to start and run car, can someone draw me a diagram, electronic ignition Thanks