Recent content by AbodyBB

I still have interest if you still have it.

Please post photos of the trunk pan and engine compartment

The article also says the widths are the same through 1970. Axle Flange to flange width on a 68-70 is wider than the 66-67 axle. Spring pads are the same width apart. Only want to advise you to measure the wheel you want to use since the article doesn’t say what axle they actually used. I’m...

Tabs on the lower control arm for sway bar were welded on in a separate process. The welds like all welds of the age were complete garbage. I have several pairs of these control arms and I’ve been fixing some of the welds. The control arms are most likely stock. Clearance issues come into play...

Thanks all. These are the bits I wanted to provide but hadn’t time to provide. I found the right shaft for long shaft 727 from cope racing transmissions. The original output shaft housing was 18 5/8.

Hello Not wanting to butt in but splines on the output shaft changed as well. It’s been a bit since I searched it but 77 definitely has the later spline angle. The old parts will install but the trans will not stay together if you use the early shaft in late parts. So use the late trans for the...

If you mean the air cleaner with the two openings where snorkels would go there is one on eBay right now. The guys asking over 700 for it. Duster / Demon 1971 Unsilenced 340 Air Cleaner Assembly | eBay

Here are a couple discussions on this topic. Sorry for the incorrect info Spindle Help 74 Duster front drum question

Uh oh. I apologize. I should have measured the spindles more closely. The spindle diameter is different. They are otherwise the same casting. Inner bearing for b body is an A6 while later A body is an A17. The difference can’t be seen it has to be measured.(.040 in) Lower balljoint is the same...

If my B body info is wrong I know someone will quickly correct me. But to find a kit like you need search for one for a 68 or 69 charger.

Yes I apologize. I wasn’t more specific. B body from 65 to 72 and all E body drum is the same spindle as 73 to 76 A body drum.

Yes indeed. The spindle used on the 73 and up drum cars was actually the B and E body drum spindle. I have both and put them next to each other. Leed as well as SSBC both have a kit that uses the Kelsey Hayes caliper and a mustang rotor. SSBC sells their kit with dual drilled rotors for small...

I’m in need of seats for a 72 duster. I need both front and rear. Front I’m hoping To find a 20/40 split Thanks

AMD reproduces both of those parts in case you didn’t know. Here is number 20. Body Components - Trunk - Trunk Floor Extensions Body Components - Trunk - Trunk Floor Extensions The other Body Components - Tail Panel - Reinforcement Brackets Body Components - Tail Panel - Reinforcement Brackets...

Just sent a PM