Recent content by acastro22

I’ll definitely do that because I’d rather pay and confirm they’re good then have no idea the condition they’re in ootb.

Thank you for the info. I’ll have my shop look them over before install.

Does anyone know if these heads come ready to go (requiring only assembly and valve lapping) or if they require a full valve job. I already have all the valve train components and was just curious to see how much these heads would take to run properly. Link to part: Mopar Chrysler SB 318 340...

Well believe it buster

Thank you sir that’s the answer i was looking for

Hellos! I ordered this intake manifold but realized it does not have a spot for the original choke that comes with my 74 d100. Is there a way around this? New carb? Or should I just reorder a new intake manifold and sell this one with no choke bolt down location

Im in search of a bare block LA 360 any leads would be appreciated. Id rather do pick up then ship but whatever ends up working out. Thank you in advance

I’ll get casting numbers tomorrow

I do stock but I bought a 360 intake but I have not bought a carb and am open to suggestions

Thank you for your insight!

Cruiser/work truck

Street car! 73 dodge d100 A727 And I have not gotten the ratio out of the diff yet.

Running but would bog out. And I will get casting numbers soon

For the intake side?

Hello! I was wondering on build advice when it comes to a 318 I own. I purchased a 360 intake and am looking for a 4 barrel carb (open to suggestions) As far as parts I have two options for push rods Stock length 7.5in vs shorter 7.380in Which would be better for a camshaft with 285/285...