Recent content by ADMC

I've been gathering parts for an 8-3/4 for my Duster. I scored an A-body housing with small bolt axles and brakes for $200. I also managed to find a 741 case with a 3.73 Sure-Grip for $300. I still need large bolt axles, brake lines, and I'll re-use the drums from my existing 8 1/4, but I...

Sorry guys, I had some stuff come up and I haven't had the time to take it all apart yet. I have followed your advice and have not driven it since. IOU all an update when I get it taken apart, though.

I figured a full rebuild is what I was in for. Thanks everyone. I'll take a look at PST stuff.

The issue I'm having is when the vehicle is moving forward the driver's side wheel toes out and tilts inward (negative camber), but if I put the vehicle in reverse the wheel straightens back out. The passenger front acts roughly the same way, but much less dramatically. I'm assuming it has...

You're probably right, he didn't turn it over for me but did say that the motor that came out of the same car (which he says was a 72-74 Newport) was a 4006630-440, which looks like a later 440. Which if it came out of a C-Body, it's probably way too wide to put into an A-body without a lot of...

Yeah I'm gonna have to ask him to do that. The casting numbers aren't matching up with anything I'm finding and that angle is anything but informative. I'm hoping it isn't an 8 1/4, that's exactly what I'm trying to replace lol.

Hey guys, first post, looking to buy a rear end from a guy on Craigslist and this is the only picture he's sent me. He says the casting number is "3 23189" but I can't find anything that matches those numbers after quite a while on Google. There's a 440 and what appears to be a BB 727 in the...