Recent content by agrevbuzz

Thanks for the diagrams too they really helped

Yes!! Got it fixed. Toe was an inch out

Did complete front end stock on 76 dart. Using some suggestions I was able to get it to an apparent 0 camber. Like an idiot I drove for a while without greasing the new tie rods (among other things). Now as I drive the camber goes negative (I think that’s right) wheels look like /——\...

I need the right side to make it match. I have a valiant lens on there now so I can use it. Ha. It’s the lens for the four door plain Jane dart. Thanks.

thank you. So does it keep flow from happening when ac is on? Make it to where water only goes to heater core of heater is turned on?

I’m working on a 76 Dart 225 slant six. Replacing hoses because they’re old. But I wonder what is this? Heater hose runs right through it

Still having trouble with the turn signal lights. I put a new switch and new flasher in. fuses are all testing ok. was messing with stuff in the trunk and tried them (don't know why) and they worked for about a minute. Could a wire be grounding on the frame? how can I tell?

How, I have them pressed in *** far as I can. The tops are on the post and the adjuster is all the way in. I don't know how I can push them in any more.

A little History first. While driving back in 2000 I had a problem. The parking brake light came on. I stopped the car and the left rear tire was on fire. I put the fire out and looked to see if I could figure out what was happening. The entire halfshaft pulled out. I was told that I...

My '76 the shaft just slid out with the endshaft still conected by ujoint after I had disconnected the differential

My 7 1/4 is 2.76. Which was fairly common with the automatic (904) transmission. You can always take the back off and count the ring and divide it by the pinion. That will tell you exactly what your ratio is.

First off, my '76 dart was parked (differential problems) since August of 2000. I have the car running (engine lurs like a dream) and the new differential in place. When I went to check the lights, I noticed that I had no turn signals. Emergency flashers worked fine. Brake lights work and...

I have just finished changing the oil on a "new" differential for my '76 dart. While I was prepping to take the old one out and replace, I noticed oil leaking from the front of the pumpkin....Pinion Seal. Does anyone know what size the nut is that attaches the yoke to the pinion shaft?

Does anyone hear Know how to make Antifreeze.... ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? Steal Her Coat in December....:-D

I'll get some pics as quickly as I can. Thanks for the comments.