Bewy's latest activity

  • B
    Bewy replied to the thread Started logging fuel pressure.
    With A/F correct, a 300 hp engine will consume 25 gph. A safety margin is needed. This is carefully explained in the original Holley...
  • B
    Bewy replied to the thread Tuning an Edelbrock 650AVS on a stock 340.
    Agree, 9" of vac is too low. You need to find out why. Could be the cam itself, faulty in some way. Wrong cam put in box? I would...
  • B
    Bewy replied to the thread 1970 Dart 340/416 Stroker build help.
    We all need to know what the builder is smokin'......so we can increase are HP #s... What is the engine doing at idle? Do the idle...
  • B
    Bewy replied to the thread Help an old man tune a new to me 340.
    There is NOTHING wrong with the Edel carbs that could cause your problem. The cam must be fairly mild to idle with 15" of vac & only...
  • B
    Bewy replied to the thread 360 Block Lifter Ticking.
    There could be some deformation in the lifter's valve seat that the eye cannot see. Might hold up ok with cold thick oil, but leaks with...
  • B
    Bewy replied to the thread Hot coil.
    67, Capacitors PASS AC current. With DC current, the cap will charge up to the supply voltage, will NOT pass current & will...
    • img029.jpg
  • B
    Bewy replied to the thread Hot coil.
    Have you taken your meds today?
  • B
    Bewy replied to the thread 360 clicikng valve train.
    dd386, Your car looks great. Love the pin stripes....
  • B
    Bewy replied to the thread Hesitation / Stumbling, runs rich at idle.
    Unless the engine in question has very high compression, such as 12:1, or power adders, it will never need a 60,000v coil. Unlikely to...
    • img449.jpg
  • B
    Bewy replied to the thread Hot coil.
    [1] Because a statement was made about MSD in this thread that is incorrect. I did mention that Del made the statement, not you... [2]...
Show older items
Back
Top Bottom