Bewy's latest activity

  • B
    Bewy replied to the thread Anybody running the '68 4 speed 340 cam?.
    That seems low for a cam used in a production car. Hopefully somebody will chime in that has the same cam.
  • B
    Bewy replied to the thread Miloon Drive.
    That is right, no locking collar from the factory. And millions of engines from the factory performed flawlessly & had no issues without...
  • B
    Bewy replied to the thread 360 Block Lifter Ticking.
    That disk is the pumping mechanism for oiling through the prod. It can go either way. The pressure that the lifter builds up to maintain...
  • B
    Bewy replied to the thread Brake Pedal Stiffens Until I Start Bleeding the Front Brakes.
    Agree, slowly sinking pedal could be an internal leak in the m/c.
  • B
    Bewy replied to the thread Mystery of the smoking nuts.
    If the adjusters were reversed, they would be releasing the brakes, not tightening them. So I doubt that is the problem. You may have...
  • B
    Bewy replied to the thread Anybody running the '68 4 speed 340 cam?.
    Mean, If other folks are getting higher vacuum than you are in the same engine, then you need to look at what can cause loss of vacuum...
  • B
    Bewy replied to the thread Miloon Drive.
    [1] There are 'poly' gears for some engines, not sure if for Chrys. A company called BOP Engineering makes some. They work with any cam...
  • B
    Bewy replied to the thread Pinning Intermediate Shaft?.
    No, never heard of one slipping. Does that mean it can never happen? No. Considering how easy it is to add the pin, it is a good safety...
  • B
    Bewy replied to the thread Anybody running the '68 4 speed 340 cam?.
    If you use vac adv connected to man vac, you will surely increase vacuum. I would think that cam will want 25-30* at idle & you should...
    • img267.jpg
    • img287.jpg
    • img268.jpg
  • B
    Bewy replied to the thread Pinning Intermediate Shaft?.
    Define/determine 'quality'. As I said in post #18, if the interference fit is tight enough, you are good. But how do you determine how...
  • B
    Bewy replied to the thread Pick me a mini starter.
    Yup, compression, correct; but with more cubes, you are compressing more air & at some point an under-powered starter will struggle.
  • B
    Bewy replied to the thread No spark 67 valiant.
    'Still no spark'. Post #1. What was the method used to test for spark??? It is not stated. That is why you go to the end of the line to...
  • B
    Bewy replied to the thread No spark 67 valiant.
    This all getting complicated for the OP. Mulimeter & test light should stay in ther tool box at this stage. Neither can determine if a...
  • B
    Bewy replied to the thread Pick me a mini starter.
    Mayhem, Yes propaganda from PM. They probably do not have a high HP starter in their range, so trying to sell you on lower hp...
  • B
    Bewy replied to the thread 408 Stroker vs RV 440.
    I would go with the stroker.... Much lighter internals will help acceleration. And overall weight saving.
Show older items
Back
Top Bottom