Recent content by bigall

:rofl:

:worthles:

Niiiice.

How i took the engine out of mine with a bit of 50 mm angle bolted to the head in the hole on top/centre.Came out at near perfect angle as you can see.

A Carby i got off a mate i tried to get to work on my slant but it was too far gone,it's marked as a Carter RBS 0518 on the engine side,Made in Australia clearly stamped near the throttle side and Email LTD ACF IND on the fender side.

http://www.cafepress.com/+ausfahrt_womens_dark_pajamas%2C579976052?cmp=pfc--ca--us--499--579976052&utm_term=579976052&utm_content=ChannelAdvisor_US_pricegrabber&utm_campaign=Women%2527s%2BDark%2BPajamas&utm_medium=productfeed&sourcecode=affiliate&utm_source=CSE&pid=5185601.

On my shed door.

302 Found. Some handy tips for you RTom,i usually use about 2 litres of boiling water to sterilise the fermenter before adding the mix and just use a tin of whatever be it lager,draft,ale and a kilo of dextrose instead of a special mix.You can use normal sugar too.

I think this is Coool. 302 Found.

Looks like he's learning quick.

:prayer:Niiiice way to wake the neighbours up:burnout:

I got a set of repro fibreglass bezels for mine and am more than happy with the finished look,mine i got from Queensland Valiant Spares.

Mine.

My 1964 Aussie AP5 Valiant,have so far owned it for just over 3 years and have rebuilt the motor,upgraded to a later model alternator with electronic ignition,front end/rear end and recently had the seats reapholstered.Took these pics outside what was the Chrysler dealers yard.And my car is a...