Recent content by billshotrod

I am willing to separate parts make me some offers.

I have some 5.7 hemi parts for sale. It is perfect for mocking up the motor. I have a bare 5.7 block that can be built. A set of early 5.7 heads. I also have a truck and a car front timing cover and alternator for each set up. I have tti biscuit mounts for an a-body. I also have a plastic 5.7...

I have a A-body 4 speed I am putting together. It has all new syncrhos and the gears were matched to them by brewers. It will come with a billet shifter plate and a fiberglass tunnel. I would Like to get 800 for everything. Its located in Old Saybrook CT Thanks Bill

The owners of Afxer.com, Steve Mangante and Englishtown are teaming up to try and get as many A/FX cars together as possible. Any A/FX car can join us from tube chassis cars to all steel cars. The event will coincide with the annual Mopars at E-town on Saturday August 24, 2013. There will be a...

I have a few hemi parts for sale. 5.7 block that needs a little clean up Im looking for 400 for it. It does not include internals. I have a truck front timing cover w/ a water pump and alternator I would like 100 plus shipping for it. I also have a truck intake and throttle body I...

I am not 100% sure how would I tell?

Shipping will run about 100 dollars

It was run in a car and there was no noise. It was professionally built. The Best way to ship would be through greyhound so could you let me know what the closest station to you is?

let me know your zip code so I can approximate shipping. Thanks Bill

I have a radiator out of a 1972 Dodge Dart with a 318 and A/C. It did not leak when I took it out of the Car. It is original to the car but I am Swapping in a 6.1 Hemi so I no longer need it. I would like to get 50 dollars for it. It is located in Old Saybrook, CT. I have pictures upon request...

Good running 318 for sale. It was pulled out of a 1972 dodge dart about 4 months ago. The motor has good compression in all eight cylinders. It did not smoke when it ran. The cam has been upgraded to a Lunati Voodoo cam. The cam was broken in properly following lunati’s directions. It also...

I would ship this part. Thanks Bill

Aluminum Small Block Bell housing For Sale. Aluminum bell housing for 69-71 small block to a833 for sale. I have misc clutch linkage to go with it. I would like to get $120 for the bell housing and clutch linkage. Parts are located in Old Saybrook, CT

4.30 sure-grip 489 center section available for sale. It was built by Randy J out of Connecticut. It has very low mileage on it. It has a crush collar delete installed on it. It also has a big u-joint setup. It is built for a Street/Strip application. I would like to get $600 for it. It is...