Recent content by Birddog1

Thanks to all. Bought one

Sent

Will this fit a 68 dart If so I’ll take one

i need under dash heater controls with the levers for a 68 dart. I have misplaced the original. Thanks

i’ve got a 360 with a cam (unknown spec) and reworked stock heads and Edelbrock intake making 364 hp on the engine Dyno. I am considering upgrading to roller cam and lifters, aluminum heads and better lifter setup. Does anyone have an idea on power gains to see if it is worth the money. I...

I’ve been doing more research on this subject and I’ve seen the published bolt pattern at 114,114.3, and 115 so I’m going to get a wheel and see if it works. I will report the findings. Does anyone have any pics of these wheels on a dart

Thanks to all. I learned something today

So if I’m understanding this correctly. And please correct me if I’m wrong. The flat tang on the distributor fits in th already installed intermediate shaft. There should be only two ways to put it in, right or 180 degrees wrong. MRO

Does the intermediate shaft come in the built engine or do I have to get one

Ahh now I get it. Thanks

just acquired my first sb mopar (360 la) bought the distributor and it was minus a gear. With that being said every one that I have looked at online is minus a gear. Obviously I am missing something. What gear do I need an where do I acquire this item Thanks I know it’s a noob question MRO

Articles - TREMEC TKO, TREMEC Magnum & SST A41 Conversion Kits for 1964-1976 Dart, Valiant, Barracuda, Duster, Demon, & Scamp

Thanks to all. Great information

hello all sooo hopefully I didn’t make a mistake. I am building a 68 dart. I purchased an sst a41 for the 4speed option and easier hwy driving. My thinking was I could run 3.73 out back to wake up the small block off the line but cruise with moderate rpm at hwy speeds. Rear is already...

Thanks to all. Brake space is also a good term.