Recent content by bob7four

Sent you a PM

Price lowered to $50 plus shipping

Upper ball joint socket, joint separator pickle forks. Total set $25 plus shipping.

1969 Barracuda convertible boot well moulding. Good condition with small dent. $75 plus shipping

My 69 Barracuda has a plastic rear window. Can just the plastic be replaced? If so what is the process. Total top replacement with glass is down the road a ways but I would like a fresh window that I can actually see through.

Are you the moderator?

Thanks to all of you that provided good sound advice and Information. Y'all provided what I needed. To those who were more concerned with where I was supposed to be posting my questions... well whatever.

So delete it. I was NOT looking for used parts. I was looking for advice on where to find OEM parts

Sorry my bad. I think originals are small ball joints. They were replaced but wouldn't tighten in the hole. They were rack welded but one has broken loose and pulled out.

Large ball joint stamped style. For a 69 Barracuda.

Not sure who deleted my message but I was only looking for suggestions as to where to purchase NEW control arms. I am not interested in posting a parts wanted ad to buy someone's used parts. This site is exasperating at times

1969 Barracuda

I understand I have to install the snaps and that there must have been one there. Studs orovided with cover are self tapping but there is just a hole in this location. No access to the underside unless I disassemble the interior again.

Yes but what is my question.

Finally getting to putting my new Legendary bootwell cover on. All of tge snaps have to be installed. My question is about the end tabs where they look like they are supposed to attach to the top of the plastic interior quarter panel. How is i938-9474t supposed to attach? There was no snap tgere...