Bronze Barracuda's latest activity
-
Bronze Barracuda replied to the thread Will these pushrods work?.Thanks I appreciate it. I should be getting the heads back from the machine shop this week. I'll let you know as I may need shorter... -
Bronze Barracuda replied to the thread Will these pushrods work?.Ok that makes sense. I'll have a look see.
-
Bronze Barracuda replied to the thread Will these pushrods work?.Thank you, and yes I was referring to the pushrod where it dead ends to the rocker. I'm curious what the reasoning is for drilled...
-
Bronze Barracuda replied to the thread Will these pushrods work?.Thanks. I've had the pushrod holes enlarged. Hopefully it'll be enough to provide clearance
-
More Information for MELLING MPR381 I need to buy new pushrods as I have lost the original ones from my 1990/91 360 I am putting a...
-
-
I would use the stock cast manifold
-
air gap based on those specs even more so with 3.55s and a 30 tire and that weight
-
Bronze Barracuda replied to the thread Intake coices.I dropped mine off with block heads and crank and I'm at about 3,700 right now completely ridiculous. Line hone, oversize, deck, crank...
-
I have a set of 2.02 J heads in a machine shop now, dropped them off with $200 down ,don't know what the final damage will be but I...
-
Sell them both, get an airgap. https://www.summitracing.com/parts/edl-7576/make/chrysler...
-
Bronze Barracuda replied to the thread Intake coices.If the budget was unlimited, for sure. I'm already way over budget in the damn machining!
-
Bronze Barracuda replied to the thread Intake coices.Yeah sounds like the heavy stock 4bbl will be my best option
-
Smaller cam and a Performer or stock intake for a heavy truck.
-
Bronze Barracuda replied to the thread Intake coices.It's going into my Ramcharger. 3.55 gears 30" tires. Will be used as a daily driver. So it'll rarely see 5000rpm
-
I'm building a 360 small block with 8.7 CR a 224 @ .050 duration with a 500 lift and magnum exhaust manifolds. I have two intakes a...
