Recent content by Bruce ARP

In case anyone needs this info. There are 3 different parking brake levers. The set for the 7 1/4 rear end measures 6.5 inches long. For 8 1/4 and 8 3/4 rear ends, if you have 10 inch brakes, they are 7 inches long. For 11 inch brakes they are 8 inches long.

So I have 10 inch brakes on my Duster and I found a set of Bendix 307654 (L and R) I am not able to cross this number to a Chrysler number, so how can I tell if these Bendix levers are for 10 inch or 11 inch brakes? Thanks for the help!

So I have a 74 Duster that came with slant 6. Small 5x4 bolt pattern. I now have a 8 1/4 rear end from a B body. The rear end is 3 inches wider than the stock rear end. That means 1.5 inches on each side wider on the rear. Can someone with a similar setup give me some wheel advise? Thank you!

I had a 1940 dodge coupe that I put a 5.7 and a NAG in. I had a Dodge Charger doner and got the entire drive train out of, even the independent rear end. In order to use the Straight Wire harness , I had to have the rear wheel sensors, the break module, computer for transmission and of course...