Recent content by Burns

1962 Dart = B-body I have TTI headers on my 63 and they fit well. Steve

Hello out there, I have money. But no trim.

I need cast C-notch trim driver side. Help Steve

I used these with 3m rope seal ebay item #290560869093

Looking for new weatherstrip kit for my dart. Any suggestions one way or the other. Thanks for your input. Steve

Here it is

I think I have one, send you a pic if its a 68 Steve

Try Bob at Blanchly auto glass in Oregon 541-925-3280

Its the bad gas and new gas,the new gas has alcohol in it. It cleans all the gunk out and hangs open the intake valves. Take the gas tank out and have it boiled out. I have seen this happen on two new engines, both suffered mechanical damage. Good luck Ihope you catch this in time

The factory carbs have a bleed hole down inside the venturi, thats why they wont hold a vacuum. I test them by disconnecting the outer carbs, then run it hard. Good luck

Here is a picture, back in the day. I have one mocked up on a 68 dart that Im working on, not sure i like it just stuck on the side. Its a lot more work to set in the panel.

Two things that work for me .023 Easy grind wire and using the edge of a cut off wheel to grind just the weld beads, heps keep the heat out of the panel have fun