Recent content by chastee1

Ah Thank You! I had a VM from someone that stated to check them out, but I couldn't hear it well and kept searching for variations of "Archie Specialties". R/T makes way more sense. I'll try them on Monday!

3/4" wide by 5/8" tall

Any chance you have some of the plastic trim pieces that snap that trim into the sheet metal? I'm in need of 5. That looks like it's from a "Custom" and I'm having a heck of a time finding the trim clips specific to the custom side trim going on my sheet meal. Thanks!

Hello - I just had the side trim redone for my 69 dart custom and I’m in need of 5 of the clips as seen in the photo below that snap into the body and the back channel of the trim piece. no luck finding a place that sells them new - so if someone knows where to find them a referral would be...

Original glass. Has some scratching in center that would be too deep to polish out (where I have hand in photo). Decided to get new glass. Going to trash on Monday morning but hoping someone here/nearby could use it. free Grosse pointe, MI pickup only. Protected in box with urethane inserts...

Going to buy a trim removal tool with the lever action handle (like the Glarks universal tool on amazon) rather than using the plastic prybar stule ones I have. I'll follow a technique I saw of using a thin piece of plastic slid between the trim and the tool to prevent scratching. Man -...

Going to remove one of the front fender side trim pieces as well to fix a small dent...I can't find an acorn nut on either the leading or trailing edge. Afraid to pull to hard to "pop off", but is the entre front fender trim just pop off?

Thank You Grampscamp! Arrived with today's mail and immediately installed it. Interior finishing touches are pulling together the cockpit nicely!

Thank You! I just bought the ones from ebay in the link you sent. What's funny is so many different places sell the wrong style and list them as fitting this application. Even the seller on Ebay with the correct ones also sells the "wrong" ones and it lists 69 A body bench seats as a correct...

Now those look quite different than what I bought! Thanks. Is this what the stock ones look like?

Thanks!

Unfortunately no. It’s notched out for the release lever, but still tons of interference and no notch with that bottom pin. If there were bench seats with seat backs that didn’t release forward id think maybe that’s the cover I bought.

Yes - holes don’t line up the other way.

69 dart custom 2 door. Bench front seat - seat backs split 50/50 and pivot forward for rear access. Bought two hinge covers from Mancini, but per pics below they interfere with the pin on the seat back that catches/releases for pivoting forward and snapping back in place. Any thoughts...

Awesome! Thank you. Tried sending a private message but it's telling me your inbox is full. Are you able to PM me to start the convo?