Recent content by chisel

  1. chisel

    Small block keeps blowing the oil filter off?

    I've had an oil filter gasket stuck to the block. When putting on new oil filter it has 2 gaskets on it now. That will blow oil everywhere.
  2. chisel

    Too much intake? RPM Air Gap on a stocker 360

    Weiand Stealth runs 0 to 6800 rpm
  3. chisel

    1971 Scamp performance

    Have you tried it in 1st gear, more vaccum,from a stop. rear butterflies will open. Wot. 2nd gear 50/50 open . Drive or 3rd gear ,front butterflies are working for cruising. Lent my car to my brother, everything beat him light to light to work. Lol, phones me, l tell him to put it in first and...
  4. chisel

    Don’t even know where to begin

    If it's a vacuum secondary Carb. Try transmission in 1st gear.
  5. chisel

    How Much Nitrous Can The Stock Pistons Handle?

    Started with a super power shot nos system. Late 70s. 75 hp 125 hp jets. Engine no problems. Drive train needs attention,ujoints .etc .I used it only in 2 and 3rd gear, traction limited.Car was blast to drive. I run a cheater system on a nitros built 340 stroker now.14 years ,nitros converter...
  6. chisel

    Mild 340 build runs hot

    Premixed coolant.50/50
  7. chisel

    416 with Comp Cams XE275HL Hydraulic stick

    I run a nitros cheater plate ontop of the Stealth intake.Also use m/t drag radials.
  8. chisel

    Stock Stroke 340 Build with NC Engine Builder

    Timing 34 degrees, top right of dyno sheet. Nice build.
  9. chisel

    416 with Comp Cams XE275HL Hydraulic stick

    340/419. I've been running the Stealth intake for 13 years.Excellent street intake. Comp hydraulic roller 562/580
  10. chisel

    [SOLD] 273 Mechanical Rockers and Pushrods

    Interested in the 273 rockers.Need them shipped to Ontario Canada.
See more
Back
Top Bottom