Recent content by cktasto

Agreed

I’ll take a pillar trim. Let me know shipping to 94588 zip. any chance you have right side trim ?

thanks guys, appreciate the feedback.

Would the A/C system from a 69’ Dart fit in a 68’ fish. Both are 318 cars. The fish was originally an A/C car. Different controls? Thanks Charlie

If you need to bend over to pick something up, you kick something else over to it so you can pick up two things, not just the one.

Located in Pleasanton CA. 2 hoods, 1 door with no internals Pick up only

Ours is one piece, not the most expensive or the cheapest. Probably one of the best buys I’ve ever made

Had ours for almost 10 years. One of the best Things we ever bought.

The second set of headers didnt come out as nice as first. I think the temp was too high on the first cycle. Came out burnt looking. intake manifold looks good tho

Just cycled the parts again. First cycle 350-400 for 20 min. shooting for 450 this cycle and then 600 or as close as i can get Still going to do three cycles per VHT instructions

Not bad. Kind of hard to regulate the temp. VHT says to heat to 250 then 450 then 600 seems to be OK but wont know till i install them an run for awhile. Hardest part is getting the temp right. im doing second set of headers and intake manifold today. Supposed to be at 250 for first cycle but...

VHT ceramic paint, curing in buddies barbeque

1980s miller dialarc. Wieghs about 500lbs but will weld steel and aluminum

Hi, How much would you like for them. Do you mind shipping to California?