Recent content by couper 340

Installed my brand new Fitech inline fuel pump today and than said to my self let me make sure it works so put 12v to the pump and it just clicked so tapped it with a soft rubber hammer with the power to it and it just clicked . Now i know it should run so i said to my self maybe it has some...

TCI TRANSMISSION SHIELD KIT I never used it but is out of date all parts are there i did paint it hemi orange fits big and small block sells on jegs for $292.95 Only asking $125.00 plus shipping mod needed to fit . shipping from Maryland 21783

let me re check it and see if i can get away with that i see three listing 45.60 that must be the one you have 45.79 and 45.85is yours the bigger 7290 joints and how much are you asking for it ? just checked mine looks like it may work will leave the yoke sticking out of the back of...

WANTED 46'' DRIVE SHAFT FOR DUSTER WITH 8 3/4 REAR AND 727 TRANS WOULD LIKE 7290 JOINTS 46 '' CENTER U JOINT TO CENTER U JOINT PM ME THANKS LIVE IN MARYLAND 21783

Thanks to all that info .i was hopping that was the case didn't want to use the shield just in the way.

If your racing at the track on teck insp do you have to have the lower dust shield cover on you 727 transmission or can you leave it off. MAYBE thinking to much but since the trans vent is on the front pump will the air rushing in to the bell housing cause the fluid to get forced out of the...

A set of Caltrac bars for a body # 4200 good shape some paint chipped off about 15 1/4 mile runs on them Come with all parts $310.00 PLUS shipping box is on heavy side send your zip code . I am in WESTEN Maryland 21783 if you want to pick up . P M me Can Delivered to Carlisle Friday the 12

1975 PLYMOUTH DUSTER 7 1/4 REAR END 2.76 GEAR IF I REMEMBER RIGHT DRUM TO DRUM $ 25.00 PICK UP IN WESTEN MARYLAND 21783 CHECK OIL DID NOT LOOK BAD AND TOWED THE CAR 3 HOURS TO MY HOME NO NOISE .

A set of Caltrac bars for a body # 4200 good shape some paint chips about 15 1/4 mile runs on them then sat on the car for 3 years. Come with all parts $320.00 most shipping is about $45 but send your zip code . I am in WESTEN Maryland if you want to pick up . P M me

MR GASKET VERTIGATE SHIFTER 4 FOUR SPEED A BODY I have a Vertigate shifter that i bought years ago and never used or mounted it it is for A body and has surface rust on the black parts from sitting in my garage for years box rotted away has light scratches on chrome and very small chip in...

First MOPAR i bought my wife couldn't have her driving a round in a vega any more . was a friend of mines car and he got a 1970 road runner. 1970 dodge challenger 318 slap stick 8 3/4

My first Mopar 1971 DUSTER 340 4 SPEED 3.91 POSI I bought it in 1976 it had a 318 because the guy before me blow it up i found a 1971 cuda in a junk yard and bought the engine for $200.00 sold it in 1990 .

I had 3 sets of magnum heads i bought over the years when i went to use them the machine shop told me there were all cracked and there were. Don't wast your time or money on used magnum heads you will burn your valve and seat

OK THANK YOU Can use nice ones.

OK tHANKS