CRUZE 418's latest activity
-
Anyone have any personal advice on Air Tracking devices? -
CRUZE 418 replied to the thread 318 Oil Pan Gasket/Sealing techniques?.I too faced your same problem with my '72 318. In my case, it was time to overhaul a 50 year old engine. Wasn't really sure what the...
-
CRUZE 418 replied to the thread 318 Oil Pan Gasket/Sealing techniques?.Did half of that, was going to cut those tabs off this time. Though I haven't had a problem in the past, I obviously am doing...
-
CRUZE 418 replied to the thread 23 or 18 spline?.Well, I am still waiting to break something with the junk clutch, have'm in two cars, one is a Hemi car, the other is a small block...
-
CRUZE 418 replied to the thread 72 dusrer 4 speed with bench seat hurst shifter handle info needed..Wouldn't Brewers know? Is a '72 still a Hurst?
-
CRUZE 418 replied to the thread 318 Oil Pan Gasket/Sealing techniques?.Next , is your pan leaking or your rear main seal? I haven't had a problem with the rear main seal before, but do now. Just...
-
CRUZE 418 replied to the thread Where to find 65 barracuda wiring harness.Evans or M&H.
-
CRUZE 418 replied to the thread Installing linkage clips.They do install without modification! Good luck to you!
-
CRUZE 418 replied to the thread Fuel Pressure.I have the Carter mechanical pump on my Sixpack, it's advertised as 6.9-8.1 fuel pressure. I installed a fuel pressure regulator and...
-
CRUZE 418 replied to the thread Installing linkage clips.Yeah, they can't catch anything. I would not say that I have tough fingers, but usually just push them into place., but they can be...
-
CRUZE 418 replied to the thread Bayonet shifter - won't give!.Oh someone will want it. Some people here think they are so cool. The Road Runner that I bought last year has a pistol grip in it...
-
CRUZE 418 replied to the thread How to mount headlight switch?.In looks, the headlight knob is attached to the rod that releases from the switch. Not sure, but don't think that you can them separately?
-
To take the rod out pull the switch on . Then push the button on the side that has the spring behind it and pull again. If the knob is...
