Recent content by cuda340s

Looking for a air grabber air cleaner (the one with the large lid), anyone have one lying around? Asking price? Photos? Let me know what ya got.

http://www.ebay.com/itm/160730018195?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649

I need of a good complete steering column and the jack set up. What do ya need for each?

BUMP, anyone? Willing to part with them at half of the new cost.

Found one. Thanks Mike!

Just discovered in the garage, a set (front buckets & rear bench) Legendary Interiors seat covers for a 67 Dart GT. Part numbers are: AA67CL00010520 & AA67CL00040520 metallic red. I thought that I’d sold these long ago when I sold the car. This set sells for over five hundred new, which is what...

In need of a gas cap for my 68 GT Dart

Anyone looking to sell a Edelbrock LD4B? I'd even consider trading my LD340 for it. Or, should I just continue to run the Edelbrock 2176 on it?

Sweet looking engine Rob, looks stock to me. Thanks for the photos and info. Good luck with your project.

What if I put a set of X heads on the engine?#-o I've been using an Edelbrock 2176 with a 600CFM carb. on the 318. Just looking for a little more performance out of my 68 318. I was going to put a 69 340 in until I discovered that both engines make the same amount of torque (340), only...

I have a Edelbrock LD340 manifold, will this unit work on my 318?

Lowered to $300.00 plus shipping. If no one what's the set (front & rear) by the end of next week:clock: I'll donate them to a local charity.

I was going through my shed and found a new set of metallic red seat covers (both front buckets & rear) that I'd purchased about three-four years ago, no longer have the car. Still wrapped in the plastic that they came in. Emblems not included, you'll need to reuse yours. These go for over...

PM your way..........

Pm sent