Recent content by cudabear67

its 2b system and I am considering cam and maybe headers that's about it. How much HP can I expect to gain w/ carb/intake upgrade? I found the d4b on ebay and got into a bidding war for it. I just thought it would be a nostalgic intake to put on my dart as it was specifically made for SB mopar...

I have a question. I got ahold of an edelbrock 600cfm performer 4 b carb with a D4B intake. Its for my 65 dart 273. Good combo? What are anyones thoughts ,advice, assistance, etc?

In colorado here. Who can give me good info on front disc brake conversion kits to purchase

In colorado here, Does anyone know where I can get 15 x atleast 8.5 and 14x7 OE's or cop wheels w/small, 5x4 bolt pattern to fit 67 Barracuda FB. Offset needs to be no more than 4.5, especially the rears. Don't mind ordering out of state if I have to.

I live in Colorado and im i took my 67 FB Barrcuda tank to a radiator shop in Ft collins. they charged me 25 bucks to boil it and seal it. tank is now fine after sitting in the muck for thirteen years.

matt71, you have a pic of how you ran the exhaust. I would like to see it as I want to do the same with my 67 FB. Also what headers did you get?

my bolt pattern is 5x4 darn i would take them too. thanks

what is bolt pattern and offset

you can find them on Classic industries. com, wheel vintiques.com and I believe summit racing. the black OE rallys, police model and the warriors are all bad ***. I have the black OE's on my 67 cuda now and they look sweet. I plan to buy either the police model or the warrior but go as wide as i...

im looking for the inner one but dont want to pay for a locking one. @#$%& expensive! just want an inner vented one. I have the flip open factory outer but it stinks up the garage because there is nothing holding in the fumes. 68gtx if its the inner one i might be interested.

Does anyone know where i can get my hands on a gas cap....jeez! i cant seem to find one anywhere and summit racing sent me the wrong one. Too small. The gas inlet is about 2" and the inner cam would be about 1 7/8" 1967 barracuda FB 3.7 slant

can someone help me out here. I cannot seem to find a gasc ap to save my life. Where can I get one. summit racing sent me the wrong one. My gas inlet tube measures roughly 2" with inner being about 1 7/8ish"

does anyone know if anybody sells bolt on dual ehxaust for slant 6. Im going to put headers on my 67 Cuda FB slant 6. havent decided on headers though if anyone can help out that would be great.

still have disc brake conversion kit. If so, how much. im in colorado.

ok so any advice for me ? I want to put 15x10 mopar OE back wheels on my 67 barracuda FB. The backspace for these rims are anywhere from 3.75 -6. I measured inner fender wall to drum base, 6". did I measure right. I am of the opinion I can fit 15x10 with right tire?