did not try drive shalf.have 4.30 posi.both turn.drive shalf turns when wheels turn.Didn`t try on ground to push.Wheels should lock off ground or on right?
got a a hold of builder.had me feel and listen for clicks.Had 5 moves and all clicked.I put it in park directly by hand and rear wheels turned over as many time as i tried to rotate them.I thought park was mechanical too.I`m talking to builder tomorrow again.If its bad he said he would make it...
Hi ,
I put a rebuilt 727 trans in my car from a very respectible trans builder,has some upgrades.forword valve body with shift kit.Ran good with stock linkage.Slap stick.removed stock linkage for Hurst Quarter Stick.seamed to shift correct when not running.started car on stands and seams all I...
Hi John,
Are you rebuilding this unit or did you?is this complete with ring and pinion.
I have a open rear 489,is this a swap or what else will i need.
Hi all,
Me and my son have been building a 72 Dart (his car)after 2yrs we finally got it all together.Went to start it and flamed out carb.rotated 180
now pops out headers.318 #302 heads .484 purple cam.found tdc drop distributor in rotated dist.180 like i said above.cant seam to get it to...
The timing cover seal really doesn't want to go in, it's kinda thin walled and I was concerned that I may be hitting it too hard and it cuts into the 2x4 like a knife. it presses in from the back, the flat side should be down right (Hollow side towards back of engine)?
Need idea for how to install new seal.old one had sleeve with flange with rubber.new one has no flange.how do I install new one for I don`t bend it
Thanks Alan- 72 318