Recent content by cwkerr007

I have a 89 d250 318 and i have 2000 ram van 5.9 and a 2003 dakota slt 4.7 so i took out the 5.9 and put it in the dakota and this model came with 5.9 but the ac lines are diff and the comp is diff in the van but the bracket is the same so i have an edy air on it for an la 360 and had to trim...

Man my 89 318 d250 np435 granny gets over 20mpg there must have been another prob

I'm sorry I'm not explaining my situation properly. I have built a 5.9 magnum and I haven't started it up yet, it is on my engine dolly with the manual trans all together and I am at the point of putting the dist in and the plugs. I haven't bought the plugs YET so the diz is from my LA 360...

I have trouble doing pics for projects because it takes me a long time to do the job to begin with cause it's just me and the dog and my wife and you can guess which one is more help lol I had my leg amputated 5yrs ago and my elbow won't bend on my left so it will probably be a month before any...

your right and from the other motors I've done this to I've only changed plugs in 1 and it was just to put some platinums that were given to me. The champions that were in it were clean but the previous motors weren't magnums and I thought maybe someone had already experimented with this since I...

Havent put plugs in the 5.9 magnum with eq heads as was stated in the opening the bottom end is oem and the question is if the ign has been changed to HEI then should the heat range of the plug change ??? Should the type of plug change platinum,irid,oem,or no need to ????

After upgrading to gm hei coils and modules I'm very happy with results on all my motors and 0 problems, but I am currently building a magnum 5.9 eq heads and was thinking about "Well I upgraded the whole ign but I'm still running the same plugs! I'm happy with the perf of the ones I'm using but...

I know this is an old thread but I had to but in there is one thing I know it's cables (motorcycle mech) Go to either motorcycle shop or your local parts house MAY have it but there are all kinds and brands of CABLE LUBE. Take the cable out of housing and clean it and flush housing blow out with...

And thank you 72bluNblu for the solution and your help:thumbsup:

Well I'm 98% pos that magnums have the same recess in the crank if I'm wrong someone step in so if my other magnums use the spacer and roller bearing then the input shaft on the trans should be right for the bushing since it is a magnum nv3500hd . But I will check that! Just so someone reading...

Yes sir it is what the factory used and this is just a perdonal preference for me I've always used bushings without a single failure and with out fear of tweeking that edge of that needle bearing. I'm sure the factory had there reasons for the change to bearings but it wasn't because of prior...

Thanks everyone for the help the advance adapt for the amc is what I needed

2000 5.9 magnum 1996 nv3500hd putting in 03 dak

Sorry just read your last message and seen link. So this will fit in the magnum crank where the linked bearing and spacer would mount

You are absolutely right I am looking for the bushing to repksce the bearing cause the outside diam is diff than the bearing. Or if there is a large bushing that will take the place of the spacer and bearing altogether