Recent content by Daniel Dugas

PRW 1.5 roller rockers for small block LA. Like new never been used, decided on going a different direction for my application. Includes everything you need to set these up (shims, pedestals, all correct hardware/studs, etc.) $450 located in WNY will ship on your dime.

14x6

Mopar 9’ front drum brake setup. Control arms, drums, backing plates. Pair, left and right. $150 OBO will ship on your dime.

Pair of small bolt 14x6 slotted mags. Roller tires $200 pickup only

Vintage Mopar:Drag Racing magazines for sale. $1 per magazine or $180 per container.

PRW 1.5 roller rockers for small block LA. Like new never been used, decided on going a different direction for my application. Includes everything you need to set these up (shims, pedestals, all correct hardware/studs, etc.) $450 located in WNY will ship on your dime.

I was actually going to run the Howard’s direct lube lifters with that cam

Alright guys need a little help here. So I have a mechanical flat tappet cam from comp. I’m a little nervous about Running it with all the issues with comp. Am I okay or should I find a different brand? -Thanks

I have the hydraulic flat tappet Speedmaster heads. They come with dual valve springs, retainers, etc. fully assembled with the springs rated for .600 lift

Hey guys I was looking at this cam for my motor but couldn’t find any valve springs rated for it could anyone help me out? Was gonna run a comp cam but am kinda shaky about it after all the problems. Thanks!

Does anybody know if Speedmaster is having their sale again this year and if so what days do they start and end? checked their page but haven’t been able to get any information. -Thanks

I’m going to use the 65cc for one because they are the ones I found and for two I figure it might bump the compression a little bit

It says that the max is .600 lift if my lift is .540 should I still change them?

Hey guys so I’m going to pick up a set of the speedmaster aluminum heads on Black Friday. But the heads I’m going to get say they are for a hydraulic flat tappet, and I have a mechanical camshaft. Am I still okay to run these heads or is this gonna be a problem? -Thanks

Hey guys so I just finished sanding down my car, so once I put some body filler on some small spots, what kind of primer should I use? Thanks in advance