Recent content by dart65

Thank you again.

Thank you I missed your first post about 1-2ounces of friction modifier. I take it my DIY steps are correct? would you recommend a cardboard gasket on the diff case cover?

Thank you for all the feedback, I will start with these -Castrol 80w-90 and Motocraft -XL3. I may experiment with Redline if there is any noise. Does anyone know of a thread with 8.25 differential DIY maintenance? I found the following link on this forum but am unsure if this is for vintage...

Thank you.

conventional or synthetic? or hypoid btw do you know what hypoid is? I cant find it anywhere. Except this Castrol gear oil mentions hypoid: https://www.classicindustries.com/product/1976/dodge/aspen/parts/cc1840.html And I forgot some say GL-4 others GL-5. Does the "GL" matter

Hello I have a 65 dart with a904 trans and 8.25 (8 1/4) suregrip rearend from a 78 aspen. I only know the rearend is a 8.25 has suregrip and 3.21 gear ratio with large bolt pattern. What type of fluid should go into this rearend? I was reading and it seems some say don't use synthetic only...

Thank you; I have the alternator mount itself but not the 65 correct "adjusting bracket" outlined in red below. The correct adjusting slide bracket would be nice, but it is the pulley set I am most interested in.

Thank you for information.

Hello I am working on an AC delete for a 1965 dodge dart with 273ci with power steering. I have already acquired a non-AC 1965 alternator mount but am having trouble finding a stock pulley set. Will this set work with the factory power steering pump/pulley from an AC car and the non ac...

Thank you for your response. I am not sure what the measurements are for the individual pulleys I need. I am looking for a matched set. I will attempt to make some measurements tomorrow for the crank pulley. I believe the pulleys/bracket are pre-1967 (64-66). The alternator bracket for non ac...

Hello, I am looking for a factory pulley set for a 1965 273 with power-steering, non-ac, driver side water pump outlet w/ bolt on timing tab. I believe it would be a 2-groove crank pulley + a water pump pulley and alternator mount?... I am converting from ac to non ac. I am only looking for the...

I don’t know, (I don’t think so) I can decode the vin if that is a deal breaker. Let me know

Engine

I will post some soon

Yes in 2010 two stage ppg