Recent content by Dart_Dodgers

It's a slide selector type setup It's a 73

Exactly. But I have a fan just fine on the A/C settings

Hi everyone, I have been trying to figure out what is wrong with my Dart, and don't have too much experience with the heat and a/c. The problem is that any of the heat selections on my control panel don't blow air whatsoever, and yet the a/c selections still blow air just fine. Anyone have any...

Ok, so here's the update. The coil checked out after the testing. It is fine. The firing order is correct (counter-clockwise) It is correctly lined up with the number one wire in the correct spot, I pulled the carb apart and cleaned it like crazy (turns out it needed it) and since then I can get...

It's a 2 barrel carter, the only number I could find that could possibly be a model number was 0-2361 I think I saw a similar one referred to as a BBD? and I adjusted the screws on the front of the carb inward a bit.

They were last night, but I then cleaned and dried them, then turned the carb down a little in case it was dumping fuel

The car has an electronic ignition and it all has checked out fine with a multimeter. And yes I have made sure about 7 times now that I am in the correct firing order and all that

The spark at the coil was good, but I could not see fuel coming from the nozzles, though I know I have gas up to the carb, and I can smell fuel all around there, and pouring the fuel down the carb did not do anything different.

The gas is good, It was pretty well empty when I got it, so the first place I went was a gas station where I put 1/2 a tank of 91 in it

Nope, it has not been removed just adjusted

I did today, not much, slightly advanced it and then slightly retarded it, then put it back to about where it was originally when neither action gave any better results

Well, between a 1/2 and 1/4 tank

Hi, I recently bought a 1973 Dart with a 318. It ran a little rough when I bought it, but it just needed a tune-up. So I bought plugs, wires, cap and rotor, oil change. Well, I put all of the new parts on, and it will not start. I have checked several times, and All of my plugs are gapped...