Dave999's latest activity
-
Dave999 replied to the thread Torsion bar mystery.so no offset hex to help in theory if they have seen some use they may well now have a slight offset which you might be able to spot... -
RobbMC makes them long on the Bell housing end so you can hacksaw em off without having to pull and reset them. It's all in the included...
-
Dave999 replied to the thread Torsion bar mystery.yeah Home - Just Suspension page 15 advertised as 0 Degree offset? Mmmm Dave
-
Dave999 replied to the thread Torsion bar mystery.i guess all you can do is work out which way they they are clocked. tape a ruler to each hex end as a pointer if both have numbers...
-
Dave999 replied to the thread Anyone ever had an old MSD box refurbished?.some stuff i got off the internet 10-20 years ago about old MSD, that prompted a few repair adventures. Australian Holden Centric but...
-
Dave999 replied to the thread Street clutch advice.if both bell and block have through holes no problem if one side is blind well i guess you could cut or machine them back id do that...
-
I ordered the RobbMc dowels and they are very, very well made. He makes them a little long, so I am curious if I'll have to shorten...
-
Dave999 replied to the thread Anyone ever had an old MSD box refurbished?.if it still works/whistles when powered up and it is the 80s/90s MSD 6AL sometimes they get a lot of corrosion inside the case...
-
Dave999 replied to the thread 8 3/4 Green Bearing Install - Retainer Plate Bent?.full story here Why Green Bearings? - Quality Body Shop Drivetrain
-
I actually went ahead and purchased the tkx and have it all installed and floor done. Will be getting the engine soon. Thanks
-
Dave999 replied to the thread Does anyone really do this to their cooling system?.you could as part of a rebuild hot tank the block it wil at least work on the rust and any rust/sand sludge i.e chemically clean and...
-
Dave999 replied to the thread Led lights.if you car is wired for emergency flash and indciator flash you will have two flasher units both would need to be replaced as both...
-
Dave999 replied to the thread Movement in the idler arm bolt?.can't say if this impacts US cars but Australian cars want through a change in the 70s where the bolt got thicker and the hole in the...
-
Dave999 replied to the thread Fitting Clutch fan!.and some of the lower profile/shorter shaft fans listed for mopar use the fact they are on a shorter shaft to cram way more fins onto...
-
Dave999 replied to the thread 2 years chasing low pressure at the caliper....two types banjo bolt/banjo end pairings those with the fluid passage in a deep groove in the banjo those with shallow or no groove in...