Daves69's latest activity
-
Should install without any modification to the rods, or clip. -
Rob there are three of them just FYI
-
Just b-a-s-h it! But your Z-bar should be installed at 90* to the car centerline from top view, and parallel to the ground from the...
-
-
Daves69 reacted to Dana67Dart's post in the thread ENGINE PLACEMENT - FOOTNOTE #39 - link died. with .Did you look around on TTIs website? Call them Monday. They may have moved it. Way back machine to the rescue.
-
It might be better to PM him.
-
Daves69 replied to the thread pivot ball alignment.:thumbsup: There are several pictures in the forum that show the stiffener in various orientation. If it's solid, it's good IMO. That...
-
-
FWIW I had to patch the inner fender because there were extra holes with bonus cracks between them. I didn't cut anything out, just...
-
I like the ones where the truck goes clear down into the water. I am not good at it by any means, but here is what I do: I put my hand...
-
Daves69 replied to the thread 340 duster 4 speed clutch pedal?.The spring in my '69 "HD" peddle set if it helps............
-
-
HOO-RAY!!!!!! Think we have it all worked out now..... :thumbsup:
-
Daves69 replied to the thread Clutch disc diameter?.Not sure you can but maybe it's possible to get a measurement from the disc OD to the input shaft spline. 4" and less would be a 9" I...
-
-
Daves69 reacted to JaeOne's post in the thread [SOLD] 1969 Plymouth Barracuda Fastback. V8 318 5.2 litre automatic $23,500.00 with .Hello there, I have a 1969 Plymouth barracuda fastback V8 318, engine 5.2 L automatic for sale. This is a beautiful car in great...
-
Clean surface, etch prime, and have at it. None of mine have ever peeled.
-
In case anyone has been on the fence, now might be a good time to buy some stuff from QA1. I was also able to use a Summit 10% coupon on...
