Hello,
Anyone have a reputable shop in the Front Range area that would install a front end suspension kit?
I have a 64 Plymouth Valiant that sits on original rubber etc. I have spoken to Bear Alignment in Loveland, however they want $1,300 to do it with Auto-Zone parts. Not gonna happen like...
Well she is out. The stamp is 369. The point of contact with the frame was the area where the cross-bar and the frame meet, or right there in the curve. The motor is not original as stated. It also rubbed quite a bit on the steering linkage at the back of the pan. More "light" pounding I guess...
I dropped a 225 in my 64 Valiant that I picked up at the yard. Great motor, but the oil pan has always been butted up against the frame on front left. Decided to go after it today by undoing MMounts raising and... ahem "denting" the offending corner. We won't go into the tools I used, but it...
Before I stop in at the local non-specialty shop I was wondering if any Colorado folks had a reputable exhaust guy to redo my stock /6 from block to bumper.
64 Plymouth 225.
Thanks
Daniel
Loveland, CO
64 Plymouth: On my right rear I have a lug sheared off and need to replace. (Righty/loosy Lefty/Tighty) Need input on gettind bad lug out. There is approx 1/2 inch of old bolt to work with. Was thinking of using C-Clamps and flat metal, didn't think a drift pin was a good idea. Any thoughts?