Recent content by dirt wagon

I have a linkage alignment issue. I have a 64 dart wagon in which I installed an a833. I believe i bought the linkage on ebay and its possibly home made. I pin all the shift levers on the shifter, hook up my linkage and the reverse arm on the shifter does not have enough travel to get it into...

They say they take .020 off and it remains the same spec. The hydraulic lifter has .080 travel so it will make up the difference.

$66 for the regrind. $60 core charge if the cam I send is useable. Billed me $126 now and I'll send my core next week. They had a cam to work with there so I'll get the cam this week.

Thanks. I called them and I'm, getting a stock grind for very cheap. Sounds like you have to change springs and maybe get the computer modified for an rv cam. Oregon Cams did not tell me this, I got it online. Thanks again.

I need a 5.9 magnum camshaft, preferably an RV cam but I would buy a stock cam if there are no RV cams out there. Thanks.

Do you have a v8 center link from this car?

You posted this quite a while ago. Is the center link still available?

What did this come out of? IM looking for a v8 center link for my 64 dart.

Im looking for a v8 center link for my 64 dart station wagon. Thank you.

Do you still have the arm rests? How much?

looking for a pair, or just driver's side door lock for 64 dart. Thanks.

Does anyone know how to test for voltage at the ECU? I have an orange box. I checked with a voltmeter at the round bare metal surfaced doohickey on the box and to ground. I had about 5-6 volts at 2000 rpm. I was told there should be a lot more but I don't know if I'm checking the right spot. Thanks.

Where do you make contact on the ecu when checking for voltage? I checked at the round metal surfaced thing and only had 5 or so volts at 2000 rpms.

I've got a MP electronic ignition with the orange box on my stroker small block. When laying into in it gets to about 3000 rpm and starts sputtering and wont get any higher. Its as if there is a rev limiter on it. Any clues? A friend suggested I check the ground on the box but im pretty sure its...

Im looking for a small block center link for my 64 dart. Thanks.